How to clean PVC window frames
You need little: lukewarm water, a dash of mild washing-up liquid or neutral cleaner, and a soft cloth or sponge. Two to four times a year is enough, more often near a busy road or under trees. Work from top to bottom and dry with a clean cloth.
Avoid these, as they dull or scratch the surface:
- abrasive cleaners, scouring pads and steel wool;
- solvents such as acetone, thinners and white spirit;
- aggressive products such as bleach or drain cleaner;
- a pressure washer at close range, which can force water past the seals.
This applies even more to frames with a wood-grain or colour foil: that layer is smooth and tough, but does not stand up to scouring. For stubborn dirt, test a dedicated PVC cleaner on an inconspicuous spot first.
Seals, hinges and locks
The rubber seals around the sashes keep wind and rain out. Wipe them once or twice a year with a damp cloth and treat them with silicone spray or a dedicated seal conditioner, so they stay supple and do not stick. Avoid petroleum jelly and other greasy products, which can damage rubber.
Give hinges and tilt-and-turn mechanisms a drop of acid-free oil or lubricant spray once a year, then work the handle a few times. Lubricate cylinder locks with a product made for cylinders, not ordinary oil, which attracts dirt.
Keep the drainage openings clear
On the outside, at the bottom of the frame, there are small slots that let water drain from the rebate. If sand, leaves or insects block them, water stays put and can find its way in past the seals. Clear them now and then with a soft brush, cotton bud or piece of wire, and rinse with a little water. If they have a cap, unclip it carefully and put it back.
The same goes for the track of a sliding door. Vacuum out sand and leaves regularly and wipe the track with a damp cloth; a clean track runs more easily and spares the rollers and seals. Spring and autumn, when you wash the windows anyway, are good moments for this round.
Condensation: inside, outside or between the panes
- Inside on the glass: the air indoors is humid, for example after showering, cooking or drying laundry. Ventilate more: open the trickle vents, run the extractor fan longer and air the room every day.
- Outside on the glass, especially on cool mornings: usually a good sign. Well-insulating glass keeps the outer pane cold, so dew forms. It disappears once the sun is up.
- Between the panes: the airtight edge seal of the double glazing has failed. Moisture has got in and cannot be wiped away. The glass insulates less well and needs replacing, though the frame can often stay.
Draughts around windows: find the cause first
Draughts around windows usually have one of these causes:
- Dirty or hardened seals. Clean and treat them; torn or flattened seals can often be replaced.
- A sash that no longer closes properly. With heavy use a sash can drop slightly. Adjusting the hinges and locking points often solves this.
- A leaking joint between frame and wall. A cracked sealant joint or missing insulation around the frame lets cold air in. It can be repaired, though it sometimes needs finishing work inside or out.
Simple test: close the window on a sheet of paper. If it slides out without resistance, the sash does not close tightly there.
When is replacement wiser?
Sometimes maintenance is no longer enough. Consider replacement if frames are warped or discoloured, several windows mist up between the panes, sashes still leak after adjustment, or you still have single or old double glazing. New PVC windows with HR++ or triple glazing then often make a bigger difference to comfort than another repair.
If in doubt, we are happy to come and look. We work in Roosendaal and surrounding areas, and we measure, supply, install and finish everything ourselves. Call 06 21 91 31 83 to make an appointment.